Remote Control Storage And Usb Connection; Remote Contol Instructions - ONKRON GM25 Benutzerhandbuch

8. Remote control storage and USB connection

Use the remote control to change the RGB lighting.
Step 1.Connect cable O to the mount, as
shown in the picture.
Step 2. Connect the USB to your device.
NOTE: The magnetic pad on the arm serves as convenient storage location for the
remote-control N (see diagram).

9. REMOTE CONTOL INSTRUCTIONS

IMPORTANT: Remove the plastic battery insert prior using the remote.
On / Off.
1
Lighting effect speed +/-.
2
Change effect mode +/-.
3
Short press 1 time – Automatic effect mode
4
Short press 5 times – 7 effect mode with single color.
Brightness +/-.
5
6
Long press for 5 seconds to lock
connection with the current mount. This
feature is rather useful if multiple units
of the same series wish to be controlled.
7
When automatic mode 4 is activated, one
particular effect can be looped. To create a
loop: activate mode 4, press 7 to initiate a
loop, and then press 6 to establish the
loop.
Single color options.
8
12
Step.1
O
Step.2
1
4
3
5
6
8
N
SPEED
MODE MODE
AUTO
SPEED
2
W
R G B
C P
Y
2
3
5
7