Technical Data - Hilti ST 1800-A22 Original Bedienungsanleitung

Status
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch. If the battery display LEDs blink, please observe the instructions
given in the Troubleshooting section.
4

Technical data

4.1 Cordless metal screwdriver
Rated voltage
Weight in accordance with EPTA procedure 01/2003
Rated speed under no load
Torque
Socket/bit drive
Operating temperature
Storage temperature range (without battery)
4.2 Battery
Battery operating voltage
Ambient temperature for operation
Storage temperature
Battery charging starting temperature
4.3 Noise information and vibration values in accordance with EN 62841
The sound pressure and vibration values given in these instructions were measured in accordance with a
standardized test and can be used to compare one power tool with another. They can also be used for a
preliminary assessment of exposure.
The data given represent the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools, or is poorly maintained, the data can vary. This can
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This can significantly reduce exposure over the total
working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
Noise emission values determined in accordance with EN 62841
Sound (power) level (L
Uncertainty for the sound power level (K
Emission sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration (vector sum of three directions), measured in accordance with EN 62841
Screwdriving (a )
n
Uncertainty for screwdriving (K)
*439718*
)
WA
)
WA
)
pA
)
pA
439718
Meaning
Charge status: 10 % to 25 %
Charge status: < 10 %
The battery has overheated.
The power tool is overloaded or has overheated.
21.6 V
DC
3.1 kg
2,000 /min
12 Nm
/ " hex. socket with
1
4
locking ring
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
−10 ℃ ... 45 ℃
81 dB(A)
3 dB(A)
70 dB(A)
3 dB(A)
0.5 m/s²
1.5 m/s²
English 17