Storage, Cleaning - Playtive PH-9187 Gebrauchsanweisung

• Warning! Batteries must not be charged or re-
activated by other means, taken apart, thrown
into fire or short-circuited.
• Always keep batteries out of reach of children.
• Do not use rechargeable batteries!
• Cleaning and maintenance must not be car-
ried out by children without supervision.
• Clean the battery and device contacts as
needed and before inserting.
• Do not expose the batteries to extreme condi-
tions (e.g. radiators or direct sunlight). Other-
wise there is an increased risk of leakage.
• Warning. This product contains a coin battery
(button cell with lithium). If swallowed, a coin
battery can cause internal chemical burn
injuries.
• Warning. Dispose of used batteries imme-
diately. Keep new and used batteries out
of the reach of children. Seek medical help
immediately if you suspect that batteries have
been swallowed or ingested.
Danger!
• Handle damaged or leaking batteries with
extreme caution and dispose of them properly
as soon as possible. Wear gloves when doing
so.
• If you come into contact with battery acid,
wash the affected area with soap and water.
If battery acid gets in your eye, rinse it with
water and seek medical attention immediate-
ly!
• The connection terminals must not be short-cir-
cuited.
Assembly
• You will need a cross-head screwdriver to
assemble the product.
Note: we recommend attaching the product
to a wall using suitable mounting materials (not
included in the package contents).
• To assemble the product, follow the individual
steps as shown in Fig. B–G.
• The stairs (6) can be used on any of the floor
levels (1), (2) and (3).
To do this, hook the first and last step of the
stairs over the unpainted wooden strip on the
floor panel.
Installing and activating the
bell (Fig. I)
1. Write the name on the nameplate (21) and
stick the nameplate to the bell (20).
2. Attach the stickers to the back of the bell (20).
3. Peel off the protective paper and attach the
bell at the desired position on the product.
4. Press the bell to activate the sound.
Activating the light fixture
Press the button on the light fixture to turn the
light on or off.
Replacing the batteries
(Fig. H)
WARNING! Observe the following
instructions to avoid mechanical and
electrical damage.
There is a battery in the bell (20) and in each
light fixture (25).
Remove the protective foil before using the prod-
uct for the first time. When the batteries are flat,
you can replace them.
1. Carefully remove the bell from the doll's house
and loosen the respective screw (20a)/(25a)
using a suitable screwdriver (not included in
the package contents).
2. Remove the cover (20b)/(25b).
3. Carefully remove the flat battery from the bat-
tery holder (20c)/(25c) and replace it with a
new battery.
Note: check the plus/minus poles of the batter-
ies and insert them correctly.
The batteries must be completely inside the
battery holder.
4. Screw the cover of the bell (20) or of the light
fixture (25) back on again.
Attach the bell to the doll's house.

Storage, cleaning

When not in use, always store the product dry,
clean, without batteries and at room tempera-
ture. Wipe clean with a dry cloth only. Wash
textiles with cold water only and let dry at room
temperature.
IMPORTANT! Never clean the product with
harsh cleaning agents.
11
GB/IE