Yealink SIP-T43U Schnellstartanleitung Seite 8

E
Basic Call Features
N
G
L Placing a Call
Using the handset:
I
1. Pick up the handset.
S
2. Enter the number, and then press the Send soft key.
H
Using the speakerphone:
1. With the handset on-hook, press
2. Enter the number, and then press the Send soft key.
Using the headset:
1. With the headset connected, press
2. Enter the number, and then press the Send soft key.
Note: During a call, you can alternate between the headset, hands-free speakerphone and handset modes by pressing the
Headset key, the Speakerphone key or by picking up the handset. Headset mode requires a connected headset.
Answering a Call
Using the handset:
Pick up the handset.
Using the speakerphone:
Press .
Using the headset:
Press .
You can reject an incoming call by pressing the Reject soft key.
Note:
Ending a Call
Using the handset:
Hang up the handset or press the End Call soft key.
Using the speakerphone:
or the End Call soft key.
Press
Using the headset:
Press the End Call soft key.
Redial
 Press to enter the placed call list, press
key.
 Press twice when the phone is idle to dial out the last dialed number.
Call Mute and Un-mute

Press to mute the microphone during a call.
 Press again to un-mute the call.
Call Hold and Resume
To place a call on hold:
Press the Hold soft key during an active call.
To resume the call, do one of the following:
 If there is only one call on hold, press the Resume soft key.
4
.
to activate the headset mode.
or to select the desired entry, and then press or the Send soft