SmartGyro Ziro Pro Benutzerhandbuch Seite 42

Assembly of your smartGyro Ziro PRO
1. Install the brakes in the correct position using the M5 hexagon spanner.
2. Install the handlebar, paying attention to the installation direction.
3. Hold the scooter, lift the handle upwards until it locks into place to lock
the frame.
4. Install the handlebar on the
down tube.
Handle
Buckle
5. Use the M3 hex key to lock the M3X4
screws on both sides of the standpipe
as shown in the picture below.
Ziro Pro Manual - EN
1. Raise the handle
upwards to lock the
scooter.
2. To fold, press the
buckle while lowering
the lever.