Connect the inline drippers 8
♦
and the shut-off valves 7 to
the distributor tubes q.
Connect the end plugs 6 to
♦
the distributor tubes q at the
points where you do not wish
to connect anything else.
♦
Clamp the wide distributor
tubes w into the long hose
holders 0 and push the hose
holders 0 into the ground.
♦
Clamp the narrow distributor
tubes q into the short hose
holders 9 and push the hose
holders 9 into the ground.
PTBS 30 A1
Operation
♦
Turn on the water tap. The base
appliance 1 regulates the
water pressure.
NOTE
The base appliance 1 has an
►
opening on one side through
which air is released if the wa-
ter pressure is too high. Make
sure that this opening is never
obstructed.
Adjust the shut-off valve 7
♦
(turn anticlockwise to open/
clockwise to close).
♦
Turn off the tap when you are
finished watering.
GB │ IE
│
7
■