Parameter List - TESY AquaThermica Compact 150 Installations- Und Wartungsanleitung

9.2.

Parameter list

Checking parameters: In any status, press this button
entered.
Adjusting parameters:
• In stand by mode, press the buttons +
• The symbol "00" will start flashing on the right side of the display. The PASSWORD should be entered!
• Press the button , than only the first digit "00" will start flashing. Use the buttons
the pass word value (24)
• Press again the button
set the password value
• Press again the button
• The first parameter will start flashing. Only the editable parameters could be changed.
• Use buttons or to go to the parameter you want to modify and press again button
mode of changing the value.
• Change the value by pressing buttons
• Quit the "Adjusting parameters mode" by pressing the button
Parameter
No.
A Lower water tank temp.
B Upper water tank temp.
C Coil temp.
D Return gas temp.
E Ambient temp.
F Electronic expansion valve opening
01 The setting temp. difference for heating
02 Valid days in holiday mode
03 E-heater start delay
04 E-heater stop temperature during disinfection
05 High temp disinfection time
06 Defrost interval
07 Defrosting entry temp.
08 Defrosting exit temp.
09 Max defrosting cycle period
10 Electronic expansion valve adjustment
11 Target overheating temp.
Opening of manually adjusting the electronic expan-
12
sion valve
13 Disinfection start time
14 E-heat start temp. difference
15 Compressor accumulative running time
16 Lower water tank increasing temp.
17 ON/OFF
18 Room temperature update period
19 Compensation temperature for the climatic curve
20 Type of temperature set control
simultaneously for at least 3 seconds
, than only the second digit of "00" will start flashing. Use the buttons
, to confirm
or and press the button
Description
and hold for 3 seconds, the system parameter checking interface will be
, to confirm
Range
-20 ~ 99°C
-20 ~ 99°C
-20 ~ 99°C
-20 ~ 99°C
-20 ~ 99°C
100~ 470
2 ~ 15°C
3 ~ 90 days
0 ~ 90min
50 ~ 70°C
0 ~ 90 min
30~90 min
-30 ~ 0°C
2 ~ 30°C
1 ~ 12 min
0 (auto)
1 (manual)
-9 ~ 9°C
10 ~ 47
0~23
2 ~ 20°C
10 ~ 80 min
0 ~ 20°C
0 (from remote signal)
1 (from PV system)
2 – 120min
-10 ~ 10°C
0 (set by TS1) ~ 1 (65°C)
22
or to set
or to
to enter the
Default
Actual testing value.
Actual testing value.
Actual testing value.
Actual testing value.
Actual testing value.
Actual testing value.
5°C
7 days
6 min
70°C
30 min
45 min
-7°C
20°C
8 min
0
5°C
35
23
7°C
30 min
2°C
0
15 min
0°C
0
Remarks
Adjustable
Reserved
Reserved
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
(N*10)
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable
Adjustable