Dmx Operation - Cameo P2 FC Bedienungsanleitung

DMX OPERATION

Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Rotate the left encoder to select the menu item DMX (see left arrow) and
confirm by pushing the encoder (ENTER). DMX mode is now enabled, and the main display is
automatically displayed. Select one of the available DMX modes in the DMX Mode menu item in
the main menu (see CONFIGURING DMX MODE).
EZ REMOTE CONTROL VIA CAMEO UNICON (optionally available)
Starting from the main display, press the left push button rotary encoder to access the menu for
selecting the mode. Turn the left encoder (SELECT) to choose EZ Remote (see left arrow) and
confirm by pressing the left encoder (ENTER). Now set the desired device ID (Fixture ID 1–8) by
turning the left encoder (SELECT) and confirm by pressing the left encoder (ENTER).
Connect the spotlight and UNICON using a DMX cable, select DMX Control in the UNICON menu,
then EZ Remote, and enter the same unit ID. Now control the spotlight using RGB, GEL, CCT or
HSI. By assigning different unit IDs, up to eight spotlights (or spotlight groups) can be controlled
separately via UNICON.
DEVICE SETTINGS (SETTINGS)
Starting from the main display, press the right rotary-push encoder to enter the main menu. Turn
the left encoder (SELECT) to choose menu item Settings (see left arrow) and confirm by pressing
the left encoder (ENTER). This will take you to the submenu for setting the submenu items (see
table, select with SELECT, confirm with ENTER, change value or status with SELECT, confirm with
ENTER, back with ESC).
Settings
Wireless = Configure wireless
Setting control (IDMX stick
optionally available)
22
EZ Remote | DMX | Auto
Fixture ID:
1
Mode Menu
WDMX On
State
Off
Signal Receive only W-DMX reception only
routing
To XLR
Backup by
XLR
Wireless control enabled
Wireless control disabled
Signal -> DMX OUT
Backup via DMX IN with W-DMX
signal interruption