Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Contents:
Check the contents of your pack.In case of missing
items, inform your distributor before commissioning.
INSTALLATION AND COMMISSIONING
Moving the machine (see page 31)
Place your U217AS on a flat, stable surface, (eg
concrete plinth);level the machine.
Warning:
Ensure sufficient clearance.
Mounting the flange:
After selecting the flange required, make sure both
flange and spindle are clean before assembly.
Tighten securely using the UA.CF13 wrench (see
page 31).
Connection:
Connect your U.217AS to the mains 220/240V mono
360W 50Hz with earth.
Switching on:
Switch on the machine (reference mark C). The
U.217AS will display 207, the programm version and
3 dashes. After initial adjustment, the U.217AS is
ready for long service.
TECHNICAL CHARACTERISTICS
Machine dimensions
(see drawing on the other side)
Weight: .......................................................... 86kg
Electrical supply
single phase: ............................... 230V±30V,50Hz
Electrical protection category
for machine: ....................................................IP52
Moteur power rating: ...................................... 50W
Balancing speed: ...................................... 140 rpm
Mesurement duration: ........................... 12 seconds
Max unbalance: .............................. 199g or 6,9oz
Precision of measurement
for weights: ......................... 1 or 5g/0,1 or 0,25oz
Prescision of measurement
for positioning: ................................................ 1,4°
Operating temperature: ........................ 0° to 45° C
Relative humidity: .................. 5 to 95% HR at 45° C
Noise level: ............................................ 70 db (A)
Measurement capacity
Machine-Wheel rim distance: ............ 50 to 315 mm
Wheel rim width: ..................................... 2" to 13"
Wheel rim diameter: ................................ 8" to 24"
Total wheel diamèter:................................. 820 mm
Max. load on the spindle: ...........................70kg
GENERAL SAFETY RULES
The wheel balancing system must only be used by person-
nel with proper training and qualifications, and only within
the range of applications for which it is designed (eg for
wheel-balancing on light passenger and light utility vehicles
or motor-cycles) in accordance with the instruction manual
and with FACOM-approved tooling for wheel retention.
It is forbidden to remove or render the system of safety
mechanisms inoperative.
Facom accepts no liability for damage or injury caused by
system operation where these arise from unauthorised chan-
ges made to the wheel-balancer or to its accessories. All
work on the electrical or electronic systems must only be
carried out by authorised and qualified personnel.
The system operator must abide by general rules for safety
at work (protective gloves, footwear, etc...).
MAINTENANCE
Before carrying out any maintenance or troubleshooting on the
wheel-balancer, disconnect from the power supply. Dismantle and
lubrificate the flange. Regularly wipe the spindle nose with an
oily cloth. Clean the front panel regularly with methylated spirits or
silicone-based cleaning products. Never use organic solvents such
as trichlorethylene, petrol, acetone or other thinners. Avoid water
splashes either inside or outside the machine.
If the system seems to be malfunfioning, do not remove or dismantle
any part of the apparatus until you have checked:
- That the power supply is properly connected
- That the flange is correctly fixed in place and that vehicle
wheels are firmly held
- That wheel rim dimensions have been correctly entered.
other anomalies
- contact After Sales Service*
*See last page.
h:1050
50 mini
1030
550 maxi
7
Werbung
Inhaltsverzeichnis
