Care And Maintenance; Cleaning And Drying - Hilti PML 32 Bedienungsanleitung

9. Care and maintenance

9.1 Cleaning and drying

– Blow dust off the lenses.
– Do not touch the glass with your fingers.
– Use only a clean, soft cloth for cleaning. If necessary,
-NOTE-
– Do not use any other liquids as these may damage the
– Observe the temperature limits when storing your
9.2 Storage
Remove the tool from its case if it has become wet. The
tool, its carrying case and accessories should be
cleaned and dried (max. temperature: 40°C / 104°F).
Repack the equipment only when it is completely dry.
Check the accuracy of the equipment before it is used
after a long period of storage or transportation. Remove
the batteries if the tool is not used over a long period.
Leaking batteries may damage the tool.
Printed: 07.07.2013 | Doc-Nr: PUB / 5070064 / 000 / 00
moisten the cloth slightly with pure alcohol or a little
water.
plastic components.
equipment. This is particularly important in summer if
the equipment is kept inside a motor vehicle (storage
temperature -20°C to +63°C / -4° to 145°F).
9. Care and maintenance
62