Master-Slave Mode - IBIZA LIGHT ASTRO Bedienungsanleitung

2. Connection to a DMX controller: The DMX512 signal must be connected to
the INPUT and OUTPUT sockets of the unit. Keep the cable run as short as
possible in order to avoid signal losses and interference from other units.
The cable length should not be longer than 100m.
3. Use a standard 3-pin XLR lead to connect the unit to a DMX controller. The
XLR connector is wired as follows:
XLR Wiring
Display panel operation
After start up, press MENU to enter into Menu mode.
Use the UP or DOWN buttons to select an item and
press ENTER to confirm.
Setting of the DMX address
Display Setting Function
A1 1 Red light on Mode
A1 1
A1 9 Motor rotation from fast to slow
A2 1 Green light on Mode
A2 1
A2 9 Motor rotation from fast to slow
A3 1 Blue light on Mode
A3 1
A3 9 Motor rotation from fast to slow
A4 1 3 colours jumping to change patterns
A4 1
A4 9 Motor rotation from fast to slow
A5 1 7 colours jumping to change patterns
A5 1
A5 9 Motor rotation from fast to slow
A6 1 Fade-in & Fade-out mode 1
A6 1
A6 9 Motor rotation from fast to slow
A7 1 Strobe mode 2
A7 1
A7 9 Motor rotation from fast to slow
So1 So1 Sound control white colour, motor rotation
So2 So2 Sound control to change color, motor rotation
© Copyright Lotronic 2011
XLR Pin Configuration
Pin 1 = Ground
Pin 2 = Data Compliment (negative)
Pin 3 = Data True (positive)
LL061LED

Master-Slave Mode

Without connecting the unit to a DMX controller, select one unit as the master
and set it to running or sound control mode and set the start address of the other
units to 1.
Channels
CH no. Value Description
0-5 Switch
1
5-255 Strobe from fast to slow
0 Red off
2
1-255 Fade in/out from dark to light
0 Green off
3
1-255 Fade in/out from dark to light
0 Blue off
4
1-255 Fade in/out from dark to light
0-5 Motor stop
5 5-127 Motor is running
128-255 Motor reverse
0-5 Start up CH1-CH5
6 5-250 Built-in program. CH1-CH5 off
251-255 Start sound control
Specifications
Power supply ....................................................................... 220-240Vac~ 30W
Light source ..................................................................... 6 x RGB LEDs of 3W
Channels ....................................................................... 6 x DMX512 channels
Operating modes ........... DMX, Sound control (built-in program), master-slave
Movement .............................................................. Level 0-260° 2-way rotation
Dims .............................................................................................. Ø17 x 17 cm