Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
conserved, so that the device can be sent back to the service centre in best condi-
tions in case of problem. The package should be closed until the installation of the
device.
4. DEVICE INSTALLATION AND MAINTENANCE
Caution! Additional Information!
Correct connection of the device to the single socket with earth is the guarantee of
proper work. In the case of inappropriate installation, the machine may cause injury.
•
The cable must not come into contact with sources of heat and sharp edges. The
cable must not sag and cannot be immersed in water.
•
Do not use malfunctioning or damaged device.
•
Parts or accessories not recommended by the manufacturer cannot be used in
the device. The act of using parts not recommended by the manufacturer, resul-
ting in loss of warranty and can lead to a direct threat to the life or health of the
user.
•
It is forbidden to move, adjusting and rotating the device in the course of work.
•
Remove the packaging after unpacking.
•
The device should be placed on a flat, steady surface which can withstand its
weight.
•
It is forbidden to place the device on a combustible surface.
•
It is forbidden to place the device near an open flame, electric stoves, coal sto-
ves or other heat sources, as well as near direct sunlight. High temperatures can
damage the cooling capacity and rise the consumption of electricity.
•
The device should be adjusted to ensure good air circulation. Must maintain a
minimum distance of 10 cm to the rear wall, the sides 15 cm and 35 cm up.
•
Do not block ventilation holes.
•
It is forbidden to place the device in areas with high humidity.
•
The device must not be connected to the outlet other than wall-mounted so-
cket, do not use a multiple outlet adapter or multiple sockets.
•
The unit should be cleaned after unpacking and before connecting to the power.
Turn on the device by pressing the poWER SWITCH ON / OFF
•
DEFROSTING:
•
Defrosting cycle for the: RCKT-140/70V; RCKT-137/70G;
RCKT-90/70G; RCKT-202/80G; RCKT-202/80VG:
The appliance will automatically run a defrost cycle every 6 hours. The
cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
1. Press and hold the UP button for 5 seconds
22
2. The defrost cycle will start immediately and the Defrost LED illumi-
nates.
Note: Starting a manual defrost also resets the automatic defrost timer.
The next automatic defrost will start 6 hours after the manual defrost has
finished.
•
Defrosting cycle for the cooling tops included in the RCKT-
140/70V and RCKT-202/80VG:
The appliance will automatically run a defrost cycle every 12 hours. The
cycle starts from the time the appliance is initially powered up.
To manually defrost the appliance:
1. Press and hold the UP button for 5 seconds
2. The defrost cycle will start immediately and the Defrost LED illumi-
nates.
Note: Starting a manual defrost also resets the automatic defrost timer.
The next automatic defrost will start 12 hours after the manual defrost has
finished.
General hints for the user.
Cooling table can be filled or upgraded when the table has reached the desired set
temperature. Never insert to the cooling table hot food and liquids as well as food
products without cover.
Food products and drinks should be stored in sealed airtight containers.
When you first filling of the table, open it and fill only one shelf in order to avoid
tipping over the table.
At the time of setting items in the table is advisable to leave space between the pro-
duct and the walls inside the device, this will allow for adequate air circulation.
If the door is opened too often, there is increased energy consumption, which could
lead to possible damage.
5. KEEP THE DEVICE CLEAN
Before cleaning or performing maintenance work, the machine must be disconnected
from the power and wait until it cools down. For cleaning, do not use harsh deter-
gents and make sure that the device does not enter the water. Never immerse the
appliance, cord or plug in water or any other liquid. It is forbidden to clean the device
with a water jet.
It is recommended to wash the cooling table regularly. The interior of the device
should be cleaned with a disinfectant suitable for the food industry. To clean, use a
damp, soft cloth and then dry thoroughly. Do not use abrasive cleaners, such as
23
Werbung
Inhaltsverzeichnis
