Maintenance, Overhaul And Repair - Pfannenberg BExBG10E-P Bedienungsanleitung

Interchangeable and Spare Parts
13)
Warning – Hot surfaces. External surfaces
and internal components may be hot after
operation, take care when handling the
equipment.
The beacon cover is interchangeable, contact manufacturing
plant for a replacement cover available in various colours.
To change the cover, unscrew the M5 socket head screws
and remove the M5 screws, M5 spring & flat washers.
Fig. 7 Removal of cover
Remove the guard and replace the old cover with the new
cover.
Old
Cover
Fig. 8 Changing of cover
Fit the guard back on to the cover and casting, align the holes
of the guard, cover and casting. To reattach the cover, the
fixings MUST be in the order shown in figure 9.
Pfannenberg GmbH · Werner Witt-Straße 1 · D-21035 Hamburg · Tel.: 040/7 34 12-0 · www.pfannenberg.com
03/2022
M5x16 Hex
Socket Screw
New Cover
Page 5 / 5
Fig. 9 Cover and Guard Fixtures

Maintenance, Overhaul and Repair

14)
Maintenance, repair and overhaul of the equipment should
only be carried out by suitably qualified personnel in accord-
ance with the current relevant standards:
EN60079-19 Explosive atmospheres - Equipment re-
IEC60079-19 pair, overhaul and reclamation
EN 60079-17 Explosive atmospheres - Electrical in-
IEC60079-17 stallations inspection and maintenance
To avoid a possible ELECTROSTACTIC CHARGE the unit
must only be cleaned with a damp cloth.
Units must not be opened while an explosive atmosphere is
present.
If opening the unit during maintenance operations a clean en-
vironment must be maintained and any dust layer removed
prior to opening the unit.
Flameproof threaded joints and cemented joints are not in-
tended to be repaired.
www.pfannenberg.com/disposal
M5x16 Hex Socket Screw
M5 Spring Washer
M5 Plain Washer
Guard
Cover
30017-016-2e