Herunterladen Inhalt Inhalt Diese Seite drucken

Maintenance, Cleaning And Repair - Konig & Meyer 24166 Nutzungsinformation

Boxenwandhalterung m/l
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

move the extension 3 with the speaker clamped in place to the desired position.

Maintenance, cleaning and repair

u Maintenance: Check regularly to ensure screw connections of attachment parts and accesso-
u
ries are firmly seated. Annual visual inspection by skilled personnel and checks by an official
u
expert every four years are recommended.
u Cleaning: Use a slightly damp cloth to clean the speaker wall mount.
u
Do not use chlorinated or abrasive cleaning agents. These will cause damage to the surface
u
and varnish.
u Repair: Immediately repair any damage that occurs and stop using the speaker wall mount.
u
Maintenance work may only be carried out if you have the necessary knowledge. If any parts
u
are missing, contact the manufacturer at www.k-m.de. Here you can find a corresponding
u
spare parts list by entering the article number on the type label. Use this page to reorder
u
missing or damaged components.
Fault and troubleshooting
Fault/cause
Mount is unstable and wobbly
Loudspeaker does not stand
securely
There is an additional clamping mecha-
nism on the bottom of the extension, next
to the clamping screw. This M8 nut 1 is
used as an additional means of securing
the speaker when it is permanently instal-
led. After the speaker is placed, it must be
screwed tight in all cases. After that, place
the M8 protective cap over the nut. The
clamping screw 2 can be used to adjust
the inclination in infinite variations. To do
this, loosen the locking nut, use the clam-
ping screw to set the desired position, and
then re-tighten the locking nut. To swivel,
Check/Remedy
● Check the screw connections between the wall and mount
plate, mount plate and pivot joint, and pivot joint and ex-
tension and tighten if necessary.
● Check to ensure that the speaker is placed inside the
clamping range of the mount.
● Check to ensure that the speaker is placed up against the
contact points of the extension.
● Check to ensure that both clamping mechanisms are
tightened securely

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

24167

Inhaltsverzeichnis