Becker Centronic TimeControl TC52 Bedienungsanleitung Seite 40

Connection as a drive controller
Warning
• Risk of injury by electric shock.
• Terminal connections must be carried out by an authorised electrician!
• If more than one drive is controlled using the TC52, the drives must be
decoupled by relay controls. This decoupling is not applicable to Becker drives
with electronic limit stop.
Always observe the switched current of the device.
1. Connect the power supply unit to the TC52 as follows:
PE
N
L
bridge
command
2. Put the protective caps back on the power supply unit.
3. Fix the power supply unit in the box.
Put the operating device in the frame and plug it into the power supply unit.
Tubular drive
green/yellow
blue
brown/black
black/brown
single central
command
40
Operating Instructions