Bosch PAM17000 Gebrauchsanweisung Seite 27

• The sliding window/balcony installation
accessory can also be used (See
"Description of accessories"). Fig. 15: a, b,
c, d. This accessory can be used for both
horizontal and vertical windows / balconies.
a
b
c
d
• The accessory has two holes on the side to
fit it to the window / balcony with. The user
can secure it to the frame or wall with two
screws (not included with the accessory) to
prevent it from moving or falling out of place,
Fig. 16.
Instructions for Use
Permanent installation
Permanent installation is performed using the
wall grommet / window grommet. See
"Description of accessories".
J To expel hot air through the wall, it is
necessary to make a hole in the wall and fit
the wall grommet, Fig. 17.
J Remove the diffusion sleeve and connect
the air expulsion tube to the accessory.
J If permanent installation is to be performed
through the window, then it is only
necessary to use the transparent end piece
on the accessory. A 10.5-cm diameter hole
needs to be cut in the glass, Fig. 18.
Fig. 15
Notes
Do not extend the hot air expulsion tube
more than necessary (maximum length;
140 cm).
27
Fig. 16
Fig. 17
24 - 38 cm.
Fig. 18