Initial Start-Up; Brewing - Parkside PKMA 20-Li A1 Originalbetriebsanleitung

Initial start-up

• If you are using the device for the first
time or if it has been in storage for a
long time, perform the following steps:
1. Remove all packing material from the
device.
2. Clean the device housing and wash all
removable parts (see section "Cleaning
after every use").
3. To remove any residues from the de-
vice, pour 240 ml fresh water into the
water tank (
without coffee grounds/coffee pod
in the filter (
tank ( 5) is empty. Repeat the same
process at least twice. (See the section
"Brewing" for information on brewing)

Brewing

To reduce the risk of scalding,
observe the section "Special
safety instructions for coffee
makers"
1. Open the flap of the water tank (
and remove the water tank (
the bow-type handle (
2. Pour in the desired volume of fresh,
cold water into the water tank (
and slide the water tank into the de-
vice until it clicks into place.
Type
Coffee grounds
(6.5 g *)
Coffee pod (60
mm type)
* Corresponds to the volume of the sup-
plied measuring spoon (
5) and boil the water
8/9) until the water
5) using
3).
Recommended
volume of water
160 ml
120 ml
15).
3. Close the water tank flap (
4. Remove the filter holder/coffee pod
holder (
out of the guide rail (
5. Observe the following procedures de-
pending on the type of coffee:
Coffee grounds:
Open the cover of the filter holder
16). Remove the coffee filter insert
(
6) from the filter holder (
(
using the bow-type handle. Insert the
desired amount of coffee grounds into
the coffee filter insert (
the coffee filter insert (
right position using the bow-type hand-
le and close the filter holder cover
( 16).
Only use the enclosed
coffee filter insert for
brewing (
Coffee pod:
Place a coffee pod into the coffee pod
holder (
-- Make sure that the flat surface of the
1) coffee pod is facing up when placing
it.
-- Do not use torn coffee pods.
-- Do not insert more than one coffee
5) pod at a time. This would result in
overflowing hot water.
6. Hold the filter holder/coffee pod hol-
der (
it into the device guide rails (
with the filling opening pointing up-
wards. If the filter holder/coffee pod
holder cannot be properly inserted into
the compartment, check whether the
coffee filter holder (
pad is properly inserted.
GB
8/9) by pulling it forwards
12).
6). Replace
6) in the
6).
9).
8/9) by its handle and insert
6) or coffee
IE
1).
8)
12)
21