Trouble Shooting
Always check the unit and accessories before use to prevent damage and defects;
these are some of the simple checks:
1. Make sure the battery has sufficient charge and is not corroded.
2. Make sure the cables fit tightly into the connection sockets of the device. The
table below shows some common defects. If you cannot remedy the defects as
described, contact your unit provider if it is not possible to remedy in the manner
described.
Defect
The device does not
turn on
The device turns on
and then off again
The device turns on,
but does not generate
electric pulses
The unit does not
turn on even though
new batteries have
been inserted
Cause
No battery or bad battery
Battery not inserted
properly
Battery life expired
Cable broken
Cable not connected
Properly
Treatment time has
Expired
54
Trouble Shooting
Remedy
Replace battery
Insert battery
again Replace battery
Replace battery
Replace cable
Connect cable properly
Switch unit to the OFF
Position and switch back
on.
Call Customer Service