Maintenance Schedule; Maintenance - Husqvarna K 770 VAC Bedienungsanweisung

To stop the product
WARNING:
continues to rotate up to a minute after
the motor stops (known as blade coasting).
Make sure that the cutting blade can rotate
freely until it completely stops. Carelessness
can cause serious personal injury.

Maintenance schedule

The maintenance schedule shows the neccessary
maintenance of the product. The intervals are calculated
on daily use of the product.
Daily
Clean External cleaning
Cold air intake
Replace
Function inspec- General inspection
tion
Throttle lockout*
Stop switch*
Blade guard, blade guard
extender and dust shield*
Cutting blade*
Safety devices on the product on page 39 .
* Refer to
To clean externally
• Flush the product externally with clean water after
each day of operation. If it is necessary, use a brush.
54
The cutting blade

Maintenance

Weekly
Vibration damping sys-
tem*
Muffler*
Drive belt
Carburetor
Starter housing
• Move the STOP switch to the right to stop the
engine.
Monthly
Spark plug
Fuel tank
Fuel system
Air filter
Clutch
To clean the cold air intake
Note:
A dirty or blocked air intake makes the product
too hot. This can cause damage to the piston and
cylinder.
Yearly
Fuel filter
705 - 003 - 22.04.2022