Stahl 24 V Betriebsanleitung Seite 44

Technical Data
EN
Technical Data
EN
Indication
EN
LED indication
EN
Channel status
EN
Channel error
EN
"Plant STOP"
EN
24 V external supply
EN
Module requires
maintenance
EN
Operating state
EN
Group error
EN
Function indication
EN
Retrievable
EN
parameters
EN
Error indication
EN Module status and
alarms
EN
EN
EN
EN
Signal errors for each
EN
channel
EN
Signal status bit
EN
Open circuit
EN
EN
EN
Short circuit
Mounting / Installation
Installation position
Mounting type
For further technical data, see www.stahl-ex.com.
14
Digital Input Output Module 24 V
for Ex n Zone 2
Series 9472/35
LED, yellow for each channel
LED, red for each channel
"24 V" LED, yellow
"24 V" LED, green
"M/S" LED, blue
"RUN" LED, green
"ERR" LED, red
Manufacturer, type, hardware revision, software revision, serial number
• Primary / redundant internal bus error
• No response from IOM
• Configuration does not correspond to the module
• Hardware error
• Excess temperature
• Slot error
• Module requires maintenance
"1" = signal interfered; "0" = signal valid
NAMUR signal: I < 100 μA
3-conductor PNP U < 1.6 V
IN
proximity switch:
Output: I < 30 mA in ON state
R > 800 kΩ in OFF state
NAMUR signal: R < 100 Ω
3-conductor PNP U < 1.6 V
IN
proximity switch:
Output: I > 500 mA in ON state
R < 25 kΩ in OFF state
Horizontal or vertical (observe operating instructions)
On 35 mm DIN rail NS 35/15 (DIN EN 60715)
230244 / 947260310010
2017-02-28·BA00·III·en·00