Prepare The Remote Control; Power On And Setup - Philips NeoPix Ultra 2 Bedienungsanleitung

Prepare the remote control

CAUTION!
The improper use of batteries can
lead to overheating, explosion, risk of
fire and injury. Leaking batteries can
possibly damage the remote control.
Never expose the remote control to
direct sunlight.
Avoid deforming, dismantling or
charging the batteries.
Avoid exposure to open fire and water.
Replace empty batteries immediately.
Remove the batteries from the remote
control if not in use for long periods of
time.
1 Open the battery compartment.
2 Insert the supplied batteries (type AAA)
with correct polarity (+/-) indicated.
3 Close the battery compartment.
• When using the remote control with infrared
signals, point the remote control at the IR
sensor on the projector, and make sure
there is no obstacle between the remote
control and the IR sensor.

Power on and setup

1 Press to turn on the projector. The LED
on the projector turns from red to white.
• To turn off the projector, press
The LED on the projector turns from white
to red.
• The distance between the projector and
the screen determines the actual size of the
image.
Initial operation
Screen size adjustment
The projection screen size (or size of images) i-s
determined by the distance between the lens
of the projector and the projection surface.
This projector has the projection distance from
80 cm to 200 cm, and thus creates projection
image size from 20" to 65".
Digital zooming
You can use the digital zoom to reduce the
screen size up to 60%.
1 Press
the settings options. Then navigate to select
Geometry Corrections - Digital Zoom.
Another way to access digital zooming
function as follows. On the home screen,
press
shortcut options. Then select the
on the upper right of the home screen and
press OK, then go to Projection Image
Setting - Digital Zoom.
2 Press / to adjust screen size with
60-100% scaling range.
Screen height adjustment
To adjust the screen height when placing
the projector on the table, turn the angle
adjustment knob located on the bottom of the
projector.
two times.
on the remote control to display
once or more to display the
AUX MICRO SD HDMI 1 HDMI 2
icon
USB DC
9