Cameo S4 IP Bedienungsanleitung Seite 31

SYSTEM INFORMATION (System Info)
Starting from the main display, press the right push button rotary encoder to access the menu
for selecting the mode (menu). Rotate the left encoder (SELECT) to SELECT System Info (see left
arrow) and confirm by pressing the left encoder (ENTER).This will take you to the submenu for
calling up the system information (see table, selection by turning the left encoder).
PLEASE NOTE
System Info
Main CPU
DRV CPU
LED temp.
Op. hours
Display
Signal Fail
Dim Curve
Dim Response
Red Shift
PWM
Calibr.
User calibration R=
User calibration G=
User calibration B=
User calibration W=
Auto Lock
Fan
WDMX
User button 1
User button 2
RDM UID
MAC Addr.
In order to be able to access all menu items in the spotlight via the Fixture menu using the Cameo
UNICON DMX/RDM controller, the menu items Stand Alone (with all Stand Alone modes), EZ
Remote and Slave are also in the main menu, except in the Mode menu.
Vx.xx
Vx.xx
xx°F xx°C
xxxxx:xx h
Always on/off after 20 s
Hold / Blackout / User Colour 8 / Fade Out 10s
Linear / Exponential / Logarithmic / S-Curve
LED / Halogen
Off / Dim to Warm
650 Hz / 1530 Hz / 3600 Hz / 12 kHz / 18.9 kHz / 25 kHz
RAW / User / Factory / Smart
000–255
000–255
000–255
000–255
Off / On
Auto / Off / Constant Low / Constant Medium / Constant High
Off / On
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
EZ Remote / Mode Selection / HSI / Direct / Colour Coordinates
GEL / User Colour / Play Loop / Light Simulation
xx xx xx xx xx xx xx
xx:xx:xx:xx:xx:xx
31