Initial Setup (Type 2) From Body Composition Monitor - Tanita BC-401 Bedienungsanleitung

en

Initial Setup (Type 2) from Body Composition Monitor

If the BC-401 is already paired with a smartphone, the location, date and time are already set so please skip this procedure. You may
begin taking measurements right away.
Different locations across the world have different gravitational pulls. These differences affect the accuracy of the weight
measurement. You can obtain the most accurate weight readings by selecting the correct gravity setting on the scale according to
your geographical location.
1. Set your location code
When the power is off, press the SET,
Refer to the map enclosed, and press the
to select your location code.
Press the SET button to enter and save the setting.
2. Set Date
Press the or button to set year and then press
the SET button.
Set the month and date in the same way.
3. Set Hour
Press the or button to set hour and then press
the SET button.
4. Set Minute
Press the or button to set minute and then press
the SET button.
The device automatically turns off after the date and time are registered.
Note: 60 seconds or more of inactivity will cause automatic shut off during this process. No data will be saved as a result.
If you make a mistake or wish to turn the unit off before you complete the programming, press the OFF button to turn the
unit off. Settings will not be saved in this case.
To change your location code, press and hold the OFF button for 3seconds when the power is off, and then follow the
procedure above to change your location code.
To change the date or time settings, press and hold the
procedure above to change the date or time settings.
You can fast-forward numbers if you keep holding down the
When you replace batteries, press the SET,
10
or button.
or button
button for 3 seconds when the power is off, and then follow the
or
or button and then follow the above steps 2 to 4.
8
button.