Starting Operation; Working Advice - Bosch PSM VENTARO 1400 Originalbetriebsanleitung

OBJ_BUCH-39-005.book Page 22 Tuesday, June 8, 2010 1:45 PM
22 | English
Replacing the Sanding Plate
(see figure H)
Slide the SDS button for release of the sand-
ing plate 23 all the way to the right.
Remove the sanding plate 24.
Guide the sanding plate 24 from below
against the sanding plate holder and firmly
press them together.
Slide the SDS button for release of the sand-
ing plate 23 all the way to the left.
If, e. g., the front tip of the sanding sheet is
worn, you can also remove the complete sand-
ing plate and reattach it turned by 120°.
Specialty Sanding Plates
You can replace the supplied sanding plate 24
with a specialty sanding plate, which is available
as an accessory.
The specialty sanding plate is attached in the
same manner as the one supplied.
Attach and remove the respective sanding
sheets in the same manner as when changing
original sanding sheets.
Pad Extender (see figure I)
With the pad extender 26 you can sand surfaces
that are difficult to access, such as sills on win-
dows, cabinets or doors.
Pad Extender, Narrow (see figure J)
With the narrow pad extender 28 you can sand
narrow openings, slots and passages.
Pad Extender, Narrow Rounded (see figure K)
The narrow rounded pad extender 29 allows you
to sand curved and hollow areas or surfaces that
are curved inward, such as on furniture, rails or
heating radiators.
1 609 929 V23 | (8.6.10)
Operation

Starting Operation

Observe the correct mains voltage! The volt-
age of the power source must agree with the
voltage specified on the nameplate of the
vacuum cleaner. Vacuum cleaners marked
with 230 V can also be connected to 220 V.
Switching On and Off
Switch the vacuum cleaner on when the
sander is set at "0". After switching off,
wait until the sander has come to a stand-
still before placing it down. The sander can
move unintentionally.
Completely unreel the cable before putting
the vacuum cleaner into operation. The ca-
ble can heat up.
Before using the vacuum cleaner, always re-
move the plug cap 9. Pay attention that the
bypass valve 15 is never restricted or
blocked. The motor of the vacuum cleaner
can overheat und become damaged.
To start the vacuum cleaner, press the On/Off
switch 7.
To switch the vacuum cleaner off, press the
On/Off switch 7 again.
When putting the multi sander into operation,
start the vacuum cleaner first and then push the
On/Off switch of the sander 2 toward the front
to position "I". Press the On/Off switch 2 down-
ward to lock it in this position.
To switch off the multi sander, first push the
On/Off switch 2 of the sander to the rear to
position "0" and then switch off the vacuum
cleaner.

Working Advice

Keep the blower opening unrestricted and
do not crease or bend the vacuum hose. The
motor can overheat.
Always wait until the multi sander has come
to a complete stop before placing it down.
Insert the plug cap for the vacuum hose connec-
tion 9 into the vacuum hose connection 8 when
not using the vacuum cleaner for longer periods.
Bosch Power Tools