Bosch GSS Professional 230 A Originalbetriebsanleitung Seite 19

When vacuuming dry dust that is especially det-
rimental to health or carcinogenic, use a special
vacuum cleaner.
Replacing the Sanding Sheet
When attaching a new sanding sheet, remove
any dust or debris from the sanding plate 9 (e. g.
with a brush).
To ensure optimum dust extraction, pay atten-
tion that the punched holes in the sanding sheet
match with the holes in the sanding plate.
Sanding Sheets with Velcro Backing
(see figure C)
The sanding plate 9 is fitted with Velcro backing
for quick and easy fastening of sanding sheets
with Velcro adhesion.
Before attaching the sanding sheet 19, free the
Velcro backing of the sanding plate 9 from any
debris by tapping against it in order to enable
optimum adhesion.
Position the sanding sheet 19 flush alongside
one edge of the sanding plate 9, then lay the
sanding sheet onto the sanding plate and press
firmly.
To remove the sanding sheet 19, grasp it at one
of the tips and pull it off from the sanding plate
9.
Sanding Sheets without Velcro Backing
(see figure D)
Lightly lift and unlatch the sanding-sheet clamp
8.
Guide the sanding sheet 19 under the opened
rear clamping bracket 10 to the stop and clamp
the sanding sheet by reinserting the sanding-
sheet clamp 8.
Fold the sanding sheet 19 firmly around the
sanding plate. Guide the other end of the sand-
ing sheet 19 under the open front clamping
bracket 10 and clamp the sanding sheet by rein-
serting the sanding-sheet clamp 8.
Bosch Power Tools
Sanding sheets without holes, e. g. from rolls or
by the meter, can be punctured with the perfo-
rating tool 20 for use with dust extraction. For
this, press the machine with the mounted sand-
ing sheet onto the perforating tool
(see figure E).
To remove the sanding sheet 19, unlatch the
sanding-sheet clamp 8 and pull out the sanding
sheet.
Selecting the Sanding Sheet
Depending on the material to be worked and the
required rate of material removal, different
sanding sheets are available:
For the working of all
wooden materials
For coarse-sanding, e. g.
of rough, unplaned
beams and boards
For face sanding and
planing small irregulari-
ties
For finish and fine sand-
ing of hard woods
For the working of
paint/enamel coats or
primers and fillers
For sanding off paint
For sanding primer
For final sanding of prim-
ers before coating
Replacing the Sanding Plate
(see figure F)
The sanding plate 9 can be replaced, if required.
Unscrew the 6 screws 21 completely and re-
move the sanding plate 9. Attach the new sand-
ing plate 9 and tighten the screws again.
English | 19
Grain size
40—240
coarse 40, 60
medium 80, 100,
120
fine 180, 240
40—320
coarse 40, 60
medium 80, 100,
120
fine 180,
240, 320
2 609 932 790 | (6.12.10)