Veripart VPSBSW177Z Benutzerinformation Seite 59

PROBLEM
The door does
not open easily.
Water runs
over the
back of the
appliance
Water enters
the appliance
There is
too much
condensation
on the back
wall of the
appliance.
There is water
on the floor.
The
temperature in
the appliance is
too low/high.
POSSIBLE CAUSE
- You tried to open the door
immediately after closing.
- During the automatic defrosting
process, icing thaws against the
back wall.
- Products prevent water from
entering the water collection
container.
- The water collection channel is
blocked.
- The door has been opened too
often.
- The door is not completely closed.
- The stored food was not packed.
- The defrost water collection
channel is not connected to the
evaporator container above the
compressor.
- The temperature is not set
correctly.
- The door is not closed properly.
- The temperature of the food in the
fridge is too high.
- Many products are stored at the
same time.
- The door has been opened too
often.
SOLUTIONS
- Wait a few seconds between
closing and re-opening the
door.
- Wipe up the water with a soft
cloth.
- Ensure products do not touch
the back wall.
- Clean the water collection
channel.
- Only open the door if
necessary.
- Make sure the door is
completely closed.
- Pack food in suitable
material before putting it in
the appliance.
- Secure the defrost water
collection channel to the
evaporator container.
- Set a higher/lower
temperature.
- Find the cause of the door not
closing properly, remove or
move possible obstacles.
- Allow the food to cool to
room temperature before
preserving.
- Preserve fewer products at the
same time.
- Only open the door if
necessary.
58