Solo 879-14 Gebrauchsanweisung Und Originalbetriebsanleitung Seite 62

Preparing for use
g
j
k
ENGLISH 22
Loosen and turn assembly flange (j)
x Put the wheel guard on a level surface with the
x Turn out screw (k).
2
x Twist the assembly flange against the wheel
m
Limit wheel guard rotating angle with screw (k)
k
n
x Turn in screw (k) again.
Install cutting device in the outer position
x Put the cutting device on the cutting device
x Check that the ribbed belt is running freely.
x Put on the ribbed belt cover (14) again.
Adjust the ribbed belt tension
x Screw both attachment nuts (d) of the ribbed belt
x Turn ribbed belt tension screw (13) towards the
x Tighten both attachment nuts (d) firmly.
assembly flange (j) pointing up (screws (g) of the
assembly flange point up).
Hold the nut below the assembly flange with flat
pliers.
guard so that the receptacle bore for the
screw (k) is located between the centre stop and
the right stop (m) on the wheel guard. The
assembly flange is hard to twist. Securely hold
the wheel guard when twisting.
For this, guide the nut (n) below the assembly
flange with flat pliers and hold it when turning in
the screw.
Turning of the wheel guard is limited by the
stops on the wheel guard between which the nut
can be moved.
carrier in the outer position. For this, guide both
screws (g) of the assembly flange through the
oblong holes and put the ribbed belt support (i)
into the ribbed belt.
Correct placement of the ribbed belt if required.
cover onto the assembly flange screws. Only
tighten the nuts manually so that the ribbed belt
tension can still be set.
right, e.g. clockwise, to increase the ribbed belt
tension). The correct tension is reached when
the square nut (e) is on the centre mark, i.e.
between "+" and "í".