Panasonic CS-F14DB4E5 Bedienungsanleitung Seite 5

TO SELECT FAN SPEED (3 OPTIONS)
FAN SPEED
AUTO LOW
• For AUTO, the indoor fan speed is automatically
adjusted according to the operation mode.
• If the operation mode is set to Fan, the fan speed will
be fi xed at MEDIUM regardless of the temperature
setting.
TO ADJUST AIRFLOW
AIR SWING
DIRECTION
MANUAL
AUTO
• Keeps the room ventilated.
• The air is discharge evenly through 4 output vents.
AUTO 1
AUTO
• There are 3 options for auto vertical airfl ow direction.
• The vertical airfl ow louver swings up and down
automatically.
• Do not adjust the vertical airfl ow direction louvers by
hand.
MANUAL
• There are 4 options for manual vertical airfl ow
direction.
• The airfl ow direction can be adjusted as desired by
using remote control.
TO REDUCE POWER
ECONOMY
CONSUMPTION
• Recommend to use when desired room temperature is
reached.
• Economy operation can be activated in all modes and
can be cancelled by pressing the respective button
again.
ODOUR WASH
ODOUR REMOVING
• Applicable for all models.
• Helps to remove unpleasant odour from the
surrounding area during operation.
• To enable the odour removing function, press the
once.
ODOUR WASH
• To cancel, press the respective button again.
ODOUR CLEAR
• Applicable for Inverter model only.
• To remove odour and minimize the growth of odour
causing moulds in the air conditioner's interior section.
• To enable this function, press the
3 seconds.
• The unit will automatically perform Fan and Heating
modes for approximately 20 minutes and then stops
automatically.
• Recommended to open the windows during this
operation.
MEDIUM HIGH
AUTO 2 AUTO 3
ECONOMY
ODOUR WASH
for more than
ODOUR WASH
TO SET DAILY TIMER TO SET DAILY TIMER
• To turn ON or OFF the unit at a preset time.
SELECT
Select ON or Set the time.
OFF timer.
• To cancel ON or OFF timer, press
• When ON timer is set, the unit may start early before
the actual set time in order to achieve the desired
temperature on time.
• Timer operation is based on the clock set in the remote
control and repeats daily once set. For clock setting,
please refer to Remote Control preparation.
• The timer closest to the current time will be activated
fi rst.
• If timer is cancelled manually, you can restore the
previous setting by pressing
• If the main power is switched off for an hour or more,
the clock and timer will need to be set again.
OPTIONAL SETTINGS OPTIONAL SETTINGS
• To avoid unintentional operation, you can
assign a different address to each indoor
unit.
• Press repeatedly to select your desired
address setting.
Group
ADDRESS
• By default, ADDRESS 1 is selected. You
do not need to change this setting for
normal operation.
• If the address is set to GROUP, more
than one indoor unit can be operated at
the same time.
Press to restore the remote control's default
setting.
RESET
Not used in normal operations.
SET
HINTS HINTS
• Set the temperature 1°C higher in cool mode or 2°C
lower in heat mode than the desired temperature to
achieve a 10% power saving.
• Use curtains to screen off sunlight and outdoor heat to
reduce power consumption during cool mode.
TIMER
SET
Confi rm.
.
CANCEL
.
SET
Address 1 Address 2 Address 3
5