Unpacking; Setting Up - Silvercrest SSTME 600 B1 Kurzanleitung

WARNING! RISK OF INJURY!
Always make sure that the blender is switched off before
►
removing the jug from the motor block!
Use the blender only with the supplied motor block!
►
CAUTION! MATERIAL DAMAGE!
Do not use the appliance in direct sunlight or near any
►
heatgenerating appliances.
NEVER fill the blender with boiling liquids or other foods!
►
Allow these to cool to a lukewarm temperature.
NEVER operate the appliance when it is empty, i.e. without
►
ingredients in the blender attachment.

Unpacking

■ Remove all packaging materials or protective films from the appliance. Retain
the packaging, so that you can store the appliance safely or send it by post,
e.g. if it needs to be repaired.
■ Before using the appliance, check that it is free of damage; check also that
the power cable and plug as well as all accessories and appliance parts are
undamaged.
■ Clean all components carefully before using the appliance for the first time
(see "Cleaning").

Setting up

Once all components have been cleaned as described in the section "Cleaning":
■ Position the appliance so that, ...
■ 6 │ GB │ IE
–
that the mains cable passes through the recess at the rear of the appli-
ance,
–
the power plug is immediately accessible, so that it can be quickly
withdrawn in the event of danger,
–
that it is stable and not liable to slip, and so that the sucker feet can
attach firmly and the appliance cannot tip over due to vibration,
–
that the mains cable is not in the working area and thus does not present a
risk of being inadvertently snagged and tipping the appliance over.
SSTME 600 B1