Parkside PBS 350 B2 Originalbetriebsanleitung Seite 13

3. Press laterally against the band saw
blade (27).
Set point: It should be possible to push
the band saw blade approx. 1-2 mm
to the side.
4. Change the tension by turning the
clamping screw (3) until the set point is
reached. Direction of rotation as seen
from above:
⭮ Tension the band saw blade
⭯ Release the tension of the band saw
blade
Checking the position of the band
saw blade
If set points are not met: see "Adjusting the
position of the band saw blade".
1. Open the housing doors (2).
2. Take the following steps to check the
band saw blade (27) for damage,
⚠
e.g. cracks, missing teeth, etc.
WARNING! Risk of injury! A
damaged band saw blade can break!
Never operate the machine with a
damaged band saw blade. Always
mount an undamaged band saw
blade.
3. Check the position on the drive wheel
(24) and running wheel (28):
Turn the running wheel and observe
the band saw blade on the running
wheel and drive wheel.
Set point: The band saw blade runs
entirely on the black tyre of the drive
wheel and running wheel.
4. Check the position on the rear guides:
• Turn the running wheel and observe
the guide rollers (34) of the rear
guides.
Set point: The guide rollers do not
rotate continuously when the band
saw blade moves.
• Press the stationary band saw blade
back with a piece of wood.
GB
Set point: The band saw blade can
be pushed back by a maximum of
½ mm using a piece of wood.
5. Check the lateral position of the lateral
guides (Fig. B, C):
Turn the running wheel and observe
the lateral guides from the front
Set point: The band saw blade almost
touches the guide pins (33): Gap of
approx. ½ mm. The band saw blade
does not grind on the guide pins.
6. Check the rear position of the lateral
guides:
Turn the running wheel and observe
the lateral guides from the right.
Set point: The non-toothed part of the
band saw blade runs between the
guide pins.
7. Close the housing doors (2).
Check that the band saw blade is
perpendicular to the saw table
For precise inspection you will need a ver-
tical stop bracket (not included in delivery).
Alternatively, you can use the rip fence
(20).
1. Tilt the saw table up to the support
screw (36).
2. Use the stop bracket to check that the
saw table and band saw blade are
perpendicular to each other.
⚠
Check safety devices
WARNING! Risk of injury Never
operate a machine if a safety device is
damaged or does not work. Contact the
service centre.
1. Lower the saw blade guard (5) down
as far as possible.
2. Make sure that the band saw blade
cover on the saw blade guard (5) is
undamaged and locked.
3. Insert the machine plug into a wall
socket.
IE NI CY
13