Further Safety Instructions - Parkside PSS 65 C1 Originalbetriebsanleitung

away from moving parts. Loose
clothes, jewellery or long hair can be
caught in moving parts.
g) If devices are provided for the
connection of dust extraction
and collection facilities, ensure
these are connected and prop-
erly used. Use of dust collection can
reduce dust-related hazards.
h) Do not let familiarity gained
from frequent use of tools allow
you to become complacent and
ignore tool safety principles. A
careless action can cause severe injury
within a fraction of a second.
4) Power tool use and care
a) Do not force the power tool. Use
the correct power tool for your
application. The correct power tool
will do the job better and safer at the
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off. Any power tool that cannot be
controlled with the switch is dangerous
and must be repaired.
c) Disconnect the plug from the
power source and/or remove
the battery pack, if detach-
able, from the power tool be-
fore making any adjustments,
changing accessories, or storing
power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
GB
e) Maintain power tools and acces-
sories. Check for misalignment
or binding of moving parts,
breakage of parts and any
other condition that may affect
the power tool's operation. If
damaged, have the power tool
repaired before use. Many acci-
dents are caused by poorly maintained
power tools.
f) Keep cutting tools sharp and
clean. Properly maintained cutting
tools with sharp cutting edges are less
Iikely to bind and are easier to control.
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed. Use of the power tool for op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grasping sur-
faces dry, clean and free from
oil and grease. Slippery handles
and grasping surfaces do not allow for
safe handling and control of the tool in
unexpected situations.
5) Service
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of the power tool is maintained.

Further Safety Instructions

• Connect the device only to a power
point with a RCD (Residual Current De-
vice) with a measured residual current
of not more than 30 mA.
IE NI CY
9