Lavor PRO Bedienungsanleitung Und Sicherheitsanweisungen Seite 21

correctly.
- Check the secure connection by pulling on the
high pressure hose.
See g. B
- Insert the high pressure hose tightly into the quick
coupling on the appliance
See g. C
- Screw the coupling element to the water connec-
tion on the appliance.
- Attach the water supply hose to the coupling on
the water connection.
NOTE: The supply hose is not included.
- Connect the water supply hose to the water sup-
ply.
- Completely open the water tap.
- Insert the mains plug into the socket.
- Turn on the appliance "I/ON".
See g. D
- Unlock the lever on the trigger gun.
- Pull on the lever of the trigger gun; the device will
switch on.
- Switch the appliance on for a (max. of 1 minute)
and wait until the water exits at the hand spray
gun without bubbles.
- Release the lever on the trigger gun.
NOTE: Release the lever of the trigger gun; the
device will switch o again.
- High pressure remains in the system.
See g. E
- Lock the lever on the trigger gun.
Operation
See g. F
- Push the spray lance into the trigger gun and fasten
it by turning it through 90°.
- Unlock the lever on the trigger gun.
See g. G
- Pull on the lever of the trigger gun; the device will
switch on.
WARNING: Appliance with uid under pressure.
14
Keep a rm hold on the gun and be prepared to
take the kickback pressure.
See g.H
> HIGH PRESSURE LANCE
See g.IJKL
> DETERGENT SUCTION
See g.M
> HIGH PRESSURE HOSE
Use the hydrocleaner only if the hose is completely
uncoiled and extended.
See g. N
Turn off the appliance
WARNING:
- Set the appliance switch to "0/OFF".
- Shut o water supply.
- Open the hand spray gun.
- Turn on pump shortly (appr. 5 seconds) with de-
vice switch.
- Pull main plug out of socket with dry hands only.
- Remove water connection.
- Activate hand spray gun until device is pressure
less.
- Lock the trigger gun.
Machines equipped with Total
Stop:
When the machine is working, by releasing the
gun lever, the motor stops automatically to
prevent component wear during the pump by-
pass phase (motor in stand-by).
By pressing the gun lever the motor starts auto-
matically.
Attention: do not leave the stand-by mode active
for more than 5 minutes.
At the end of the operation, set the switch to
"OFF".
(if tted)
Machines equipped with delayed, low-voltage Total
Stop:
When the machine is working, by releasing the gun
lever, after approximately 15 seconds the motor
stops automatically to prevent component wear
during the pump by-pass phase (motor in stand-by).
By pressing the gun lever the motor starts automati-
cally.
EN
21