Matrix PG 2000i-2 Bedienungsanleitung Seite 20

- We recommend that you clean the device after
UK
each time finished using.
- Clean the equipment regularly with a moist
cloth and some soft soap. Do not use cleaning
agents or solvents; these could attack the plastic
parts of the equipment. Ensure that no water can
seep into the device.
8.2 Air filter (B16)
In this connection, please also read the service
information.
- Clean the air filter at regular intervals, and
replace it if necessary.
- Remove fixing bolt on the air filter cover.
- Remove the filter elements (B16).
Important!
Do not use abrasive cleaning agents or petrol to
clean the elements.
- Clean the elements by tapping them on a flat
surface. In cases of stubborn dirt first clean with
soapy water, and then rinse with clear water and
air dry.
- Assemble in reverse order.
8.3. Spark plug (B4-8)
Check the spark plug (item 17) for dirt and grime
after 50 hours of operation and if necessary clean
with a copper wire brush. Thereafter service the
spark plug after every 50 hours of operation.
- Pull off the spark plug boot with a twist.
- Remove the spark plug with the supplied spark
plug wrench (15).
- Assemble in reverse order.
8.4 Changing the oil and checking the oil level
(B9-13)
20
The motor oil is best changed when the Engine is
at working temperature.
- Only use motor oil SAE - 15W40 / (<0
5W30].
8.4.1 Fill up Oil. (B13)
- Open the oil filler plug (9) by screw it off.
- Add exactly 0.35L engine oil with an oil filling
funnel.
Or refer to content in 8.4.2.
- Screw the Oil filler plug back.
8.4.2 Checking Oil level. (B12)
- Place the generator on a slightly inclined surface
so that the dip stick is at proper position.
- Screw off the Oil Filler plug and wipe off any oil
on the dip stick.
- Put the oil dip stick back without screw into the
Oil filler.
Important!
Do not screw the dipstick in to check the oil level;
simply insert it up to the thread.
- Check the dip stick; make sure the oil level is
between "H" and "L" mark.
8.4.3 Let out used Oil (B17)
- Open the oil filler screw (9).
- Drain the used oil into a suitable receptacle by
tilting the generator.
8.4.4 Changing Engine Oil
- changing engine oil refers to the content in 8.4.3
and 8.4.1.
8.5 Oil shortage cut-out
This generator has a Low Oil level Protection
system.
O
C) [SAE -