V-Check Points Lite; Jdash1 : Tuning Controller Connector - MSI MEG X670E ACE Benutzerhandbuch

V-Check Points Lite

These voltage checkpoints are used to measure the current system voltages. A
multimeter (not included) will be required to check voltages. To measure voltage,
place test leads on the Ground (or screw mounting hole) and a specific V-Check Point.
Please refer to the manual of your multimeter for more information.

JDASH1 : Tuning Controller connector

This connector is used to connect an optional Tuning Controller module.
CORE1: Core voltage
SOC1: SOC voltage
DDR1: CPU VDDIO voltage
GND1: Ground
2
1
Pin Signal Name
1 No Pin
3 MCU_SMB_SCL_M
5 VCC5
7 PSIN#_R
9 NC
11 BLK+
13 CLRCMOS_EN
59
14
13
Pin Signal Name
2 NC
4 MCU_SMB_SDA_M
6 Ground
8 FP_RST#_R
10 OC_FS
12 BLK-
14 NC