Asembling And Hanging The Fan; Remote Control - Create WIND FOLD Bedienungsanleitung

ASE MB LI NG AND H ANGI NG TH E FAN
Cotter pin
Tip: To make it easier to feed the wires into the bar, wrap some electrical tape around the
wires. This will help you hold them together as you insert them into the bar.
• Loosen set screws and washer on top of motor housing. Remove the pins from the bar (if
you haven't already). Insert the rosette through the bar.
• Pass the cables through the bar and pull the excess cables from the top of the bar to tight-
en them.
• Place the bar inside the motor housing and insert the pins you removed earlier. Tighten the
set screws and washers.
• Lower the rosette onto the motor housing.
1. **Light
2. On / off button
3. Fan intensity control
4. Timer
Batteries (2 x AAA)
5.
6. **Color temperature
control
7. **Fan intensity control
8. Inverse function
Cotter pin

REMOTE CONTROL

Electrical wiring
Canopy
Hanging ball slot
Decorative cover
Bolt
Adapter
Fixing screw
** Function only available
when the LED board is
installed.
E NG L I SH
9