Control Panel - Parker Hiross Hyperchill Maxi ICE460 Benutzerhandbuch

4 Control
4.1

Control panel

P0
P1
P2
Display
P3
P0 Isolator switch.
Shows alarms on the display, switches off the buzzer if
P1
activated and resets alarms.
Enables access to the menu for selecting the group of
P2
parameters.
P3 Cancels an operation.
Shifts the cursor or increases the value of a
P4
parameter.
Shifts the cursor from one parameter to another or
P5
confirms a parameter.
Shifts the cursor or decreases the value of a
P6
parameter.
LED ON
P1 Alarm present.
Machine switched off by super-
P2 Machine on.
visor or digital input.
English
4.2 Starting the chiller
!
THE CRANKCASE HEATER MUST BE ACTI-
S
VATED
MACHINE.
P4
S Connect the power supply to the machine by turning the main
isolator switch QS [P0] to ON.
S Switch the cooler ON as shown in the figure.
P5
S Set the desired temperature on the controller.
P6
FLASHING
---
24 HOURS BEFORE STARTING
4.3 Stopping the chiller
When cooler operation is no longer required switch it OFF as
shown in the figure.
THE Do not turn off the main switch QS [P0] to ensure that any anti-
freeze protection devices will still receive electrical power.
4
Hyperchill (ICE460 ---760)