Tronic QI TPBQS 10000 A1 Bedienungs- Und Sicherheitshinweise Seite 17

NOTE: If your device supports 10 W wireless charging,
the 4th LED of the battery status indicator
For wireless charging below 10 W, the LED will still be the
original colour of the battery status indicator
If wireless charging does not start, move your device to be
charged more accurately to the centre of the Qi charging
surface 4
While in idle status (standby mode), the Qi status indicator
will light blue*. The Qi status indicator
9
no Qi compatible device is detected and idle for approx.
30 seconds.
When the charging process has finished (i.e. the mobile
device is fully charged) the Qi status indicator
flashing and light blue.
The Qi status indicator
detected on the Qi charging surface
remove your device and make sure that there are no
unwanted metallic objects between your device and the Qi
charging surface
To stop the wireless charging, gently pull your device away
from the Qi charging surface
cups . The Qi status indicator
5
mode). If no Qi compatible device is detected for approx.
30 seconds, the Qi status indicator
To switch off the power bank during the standby mode,
press the On/off button
and battery status indicator
9
NOTE:
*
1) Qi status indicator
(standby mode) when wireless charging has finished if the
mobile device closed the wireless communication between
the Qi charging surface
2) All devices to be wirelessly charged must comply with Qi
Standard.
until the Qi status indicator
9
and then try again.
4
3
may change back to blue colour
9
4
8
9
will go off when errors are
4 . In this case,
to release the suction
4
will light blue (standby
9
will go off.
9
twice. The Qi status indicator
8 will then go off.
and the mobile device.
will turn green.
.
8
starts flashing.
will go off if
9
stop
9
GB/IE/NI 17