Assembly And Installation - LIVARNO home 898-S-2 Bedienungs- Und Sicherheitshinweise

z Assembly and installation
Please note: dispose of all packaging
material� Decide prior to installation where
the product is to be mounted� Before drilling
the fixing holes, satisfy yourself that there is
no danger of drilling into or damaging gas
or water pipes or electricity cables in the
position where you are about to drill the
holes� Use a drill to drill the holes into the
masonry� Observe all safety instructions
provided in the operation and safety manual
for your drill� Otherwise there is a risk of
death or injury from electric shock�
When deciding where to mount the
light, pay attention to the following:
Ensure the product illuminates the desired
„
area� Make sure that the motion sensor
covers the desired area�
The motion sensor has a maximum
„
detection range of 8 m with a field of view
of approx� 100°�
Ensure that the motion sensor
„
position where street lighting will shine on it
at night� This may impair the function�
The recommended installation height is 2 to
„
4 m�
Use the fixing holes
„
bracket (for mounting on building walls
21
or corners) to mark the positions for drilling
the holes (see Figs� F and G)�
Drill the holes (dia� 6 mm)�
„
Now insert the wall plugs
„
drilled holes (see Fig� G)�
Offer the wall bracket
„
mounting surface and fix it in place with
the screws without fully tightening them
24
(see Fig� G)�
Tighten the screws in the fixing holes and
„
align the LED solar spotlight
required�
The LED solar spotlight
„
be slotted onto the wall bracket�
Aligning the LED Solar Spotlight
36
GB
9
is not in a
9
in the spotlight wall
22
into the
23
up to the
21
as
11
can now simply
11
The reflectors can be adjusted
8
horizontally (left/right) within a range of 65°
each way and vertically within a range of
65° (up) and 70° (down)� To do so, remove
the fixing bolt and then align the
7
reflectors as desired.
Now align the motion sensor
that it faces directly towards the desired
detection zone�
Please note: the motion sensor has a field
of view of up to 100°�
Mounting the solar panel
You have the option of mounting the solar
panel directly on the spotlight, on a flat
1
surface (wall/roof), or on the lawn, for
example, using the ground spike
supplied with the product�
Please note: the solar panel
positioned where it will be exposed to as
much direct sunlight as possible� Even partial
shade during the day can significantly
impair the charging process�
Orientation:
The optimum alignment is facing south� It is
better to face the solar panel slightly to the
west than slightly to the east�
Mounting the solar panel on the
spotlight
Screw the screw fixing
„
connecting sleeve
hand-tight�
Now fix the solar panel/spotlight bracket
„
in the guide holes
4
spotlight by pushing the guide rail
the bracket into the guide holes of the LED
solar spotlight until they lock into place�
Slot the solar panel
„
panel/spotlight bracket
Please note: to detach the bracket again,
very carefully press the tabs on the sides of
the guide rail until the bracket can be
5
removed�
Now plug the power cable
„
charging socket
15
, ensuring
9
17
should be
1
together with the
3
and tighten it
2
in the LED solar
10
of
5
onto the solar
1
�
4
into the
6
; to do so you must first