Electrolux JUNO JCF94181 Benutzerinformation Seite 9

Important! The operation of the appliance
goes with certain sounds (compressor and
circulating sound). This not means a
trouble, but a normal operation.
Important! The appliance operates
discontinuously, so the stopping of
Problem
The compressor oper-
ates continually
Water flows at the back
plate of the refrigerator
Water flows into the re-
frigerator compartment
Water flows onto the
floor
The lamp does not work.
It is too warm in the re-
frigerator
It is too cold in the refrig-
erator
There is too much frost
and ice
All manuals and user guides at all-guides.com
Possible cause
The Temperature Regulator may
be set incorrectly
The door does not close tightly
or it is not shut properly
The door has been opened too
frequently
Food placed in the appliance
was too warm
The temperature of the room
that contains the appliance is
too high for efficient operation
During automatic defrosting,
frost melts on the back plate
The outlet can be clogged up
Products placed in can prevent
water from flowing into the col-
lector
The melting water outlet flows
not into the evaporative tray
above the compressor
The lamp is in stand-by.
The lamp is defective.
The Temperature Regulator may
be set incorrectly
The door does not close tightly
or it is not shut properly
Food placed in the appliance
was too warm
Large quantities of food to be
cooled were put in at the same
time
There is no inside cool air circu-
lation
The Temperature Regulator may
be set incorrectly
Products are not wrapped prop-
erly
compressor does not mean being no
current. That is why you must not touch the
electrical parts of the appliance before
breaking the circuit.
Set a warmer temperature
Check if the doors close well and
the gaskets are undamaged and
clean
Do not leave the door open longer
than necessary
Allow food to cool to room tem-
perature before storing
Try to reduce the temperature in
the room where the appliance
stands
It is normal
Clean the outlet
Replace the products so that they
can not touch the back plate di-
rectly
Put the melting water outlet to the
evaporative tray
Close and open the door.
Refer to "Replacing the lamp".
Set a lower temperature
Check if the door closes well and
the gasket is undamaged and
clean
Allow food to cool to room tem-
perature before storing
Insert smaller quantities of food to
be cooled at any one time
Provide inside cool air circulation
Set a higher temperature
Wrap the products better
electrolux 9
Solution