Beper P202VAL200 Betriebsanleitung Seite 15

EN
Rechargeable Floor Cleaner Use instructions
Recharge
Fully charge the product before first use.
To load the product correctly, it must be completely assembled, with the two tanks inserted as well.
Place the docking / charging base near a power outlet and plug in the charger.
Insert the charger plug into the hole located behind the charging base (Fig. F). Place the product on the base,
taking care to fit the part under the clean water tank (in the rear area of the appliance) into the vertical side of the
base. If the product is properly seated, the LED display will light up indicating the battery level and the charging
symbol and percentage will flash.
Instructions for Use
Remove the product from the charging base. If the product has a low charge level, the vacuum cleaner and
floor brush will not work. Collect large waste such as cloth, paper, glass, cigarette butts / matches, hot ash, flour,
chemicals from the floor, which could block the electric brush or seriously damage the product.
To insert clean water into the special tank, remove it from the product by pressing the clean water tank release
button and using the handle, pull the tank outwards. Open the silicone lid and insert the water (Fig.G).
It is also possible to dilute floor cleaning detergents in water, making sure to respect the ratio 1 (detergent): 50
(water).
Do not use boiling or hot water or alcohol as a cleaning agent.
To operate the product, press the power button: the product turns on and the LED display indicates the battery
level, low speed, and active water wash indicator.
To activate high speed, press the speed selection button and the LED display will show the high-speed symbol.
To reactivate the low speed, press the speed selection button again.
If the roller brush is blocked during operation, the roller brush blocked symbol appears on the LED display. Turn
off the product, open the brush cover and remove the roller to proceed with its cleaning.
If the clean water runs out during operation, the empty clean water tank indicator lights up on the LED display
and the water wash indicator turns off.
It is possible to use the product without the water washing function, therefore with suction only, simply by leaving
the clean water tank empty: the LED display will show the empty clean water tank indicator.
To turn off the product, press the off button and the appliance will turn off after a few seconds.
Cleaning
To activate the self-cleaning function, place the product on the docking base making sure the product is charging.
Empty the dirty water tank, reinsert it and press the self-cleaning button and the function will start automatically.
It is recommended to proceed with self-cleaning after each use.
If the clean water tank is empty, self-cleaning does not work.
After each use, empty and clean the dirty water tank (Fig.H).
Detach the tank from the appliance and remove the tank cap by pulling it upwards. Wash the HEPA filter under
a jet of water as well as the float connected to the lid.
Empty the tank, remove the perforated plastic filter and wash them with water. You can use the supplied cleaning
brush to clean the various components.
Allow all components to air dry completely before assembling the product.
To remove the roller brush, lift the brush cover by pressing the button on it (Fig.I) and lift the roller. Wash it with
water.
Once the roller has been removed, the suction inlet can be cleaned using the supplied cleaning brush.
To reinsert the roller, first insert the part of the roller with the sprocket into the left part of the product base, then
insert the right part of the roller connected to the plastic roller stop. Reinsert the lid by hooking the lower part to
the base of the product and then press the upper part of the lid until you hear a click.
15