Ryobi CCS-1801/DM Bedienungsanleitung Seite 19

GB
F D
SPECIFICATION
ALTERNATIVE METHOD FOR RIP CUTTING
44. STRAIGHT EDGE
45. C-CLAMPS
46. WORKPIECE
47. RIP FENCE SCREW (WING SCREW)
48. RIP FENCE (EDGE GUIDE)
49. PLACE RIP FENCE THROUGH HOLES
KNOW YOUR CORDLESS CIRCULAR SAW
Before attempting to use a tool, familiarize yourself with all
its operating features and specific safety requirements.
Features include easily operated bevel cut and depth of
cut adjustment mechanisms, positive 0° bevel stop,
spindle lock and blade key storage compartment.
See Figure 1.
Applications
Only use your saw for the purpose listed below:
Cutting all types of wood products (lumber, plywood,
■
paneling).
Trigger Switch
Your saw is equipped with a lock-off button which
reduces the possibility of accidental starting. The lock-off
button is located on the handle above the trigger switch.
You must depress the lock-off button in order to pull
the switch trigger. The lock resets each time the trigger
is released.
Note: You can depress the lock-off button from either the
left or right side.
WARNING
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure to
do so could result in objects being thrown into
your eyes, and cause serious eye injury.
WARNING
Do not allow familiarity with your cordless circular
saw to make you careless. Remember that a
careless fraction of a second is sufficient to inflict
severe injury.
E I P NL S DK N FIN GR
English
TO ASSEMBLE OR REMOVE BLADE
TO ASSEMBLE BLADE
Remove battery pack from saw.
■
Depress latch on end of battery pack and release it
■
from your saw. See Figure 2.
Remove blade key (5 mm hex key) from its storage
■
compartment. See Figure 1.
Depress spindle lock button and remove blade screw
■
and outer blade washer. See Figure 3.
Note: Turn blade screw clockwise to remove it.
Put a drop of oil onto inner blade washer and outer
■
blade washer where they touch the blade.
Fit saw blade inside blade guard and onto spindle.
■
Note: The saw teeth point upwards at the front of saw
as shown in Figure 3.
Put outer blade washer back in place.
■
Depress spindle lock button, then replace blade
■
screw. Tighten blade screw securely.
Note: Turn blade screw anticlockwise to tighten.
Return blade key to storage compartment.
■
REMEMBER: Never use a blade that is too thick to
allow the outer blade washer to engage with the flat
on the spindle.
15
RO
H CZ RUS
WARNING
A150 mm (6") blade is the maximum blade
capacity of your saw. Never use a blade that is
too thick to allow outer blade clamp to engage
with the flats on the spindle. Larger blades will
come in contact with the blade guard, while
thicker blades will prevent blade screw from
securing blade on spindle. Either of these
situations could result in a serious accident.
WARNING
Failure to remove battery pack from the saw
could result in accidental starting and cause
serious personal injury
WARNING
If the inner blade washer has been removed,
put it back in place before placing the blade on
the spindle. Failure to do so could cause an
accident since the blade will not tighten properly.
HR
PL SLO TR