Setting The Clock; Setting The Required Temperature - Zibro SRE 139 E Gebrauchsanweisung

D
empty full
E: When the 4-digit stops
blinking, the setting has
been locked to the
indicated value.
F: The required
temperature on the left,
the measured
temperature on the
right.
4
46
Check the removable tank fuel gauge
6
filling by loosening the switch button on top of the pump (turn anti-clock-
wise), once the gauge indicates that the tank is full. Never overfill the tank,
especially not when the fuel is very cold (fuel expands when it heats up).
Let the remaining fuel in the pump flow back into the jerrycan and carefully
7
remove the pump. Carefully screw the fuel cap back on the tank. Clean off
any spilled fuel.
Check whether the fuel cap is straight and tightened properly. Reinstall the
8
removable tank in the heater (cap down). Close the lid.
C

SETTING THE CLOCK

It is only possible to set the correct time, when the heater is connected to the
mains and not burning. Use the adjustment keys
either of the two keys to switch on the function (the 4-digit ¸ will start blinking).
Next, set the hours using the key on the left ( hour) and the minutes using the
key on the right ( min.). Press once to increase the value by one step. When you
hold down the key, the value will continue going up, until you release the key
again. After approximately 10 seconds the 4-digit will stop blinking and the
setting will be locked. 5 minutes after switching off the heater, the information on
the display will disappear and the heater will automatically switch into the stand-
by position.
When the heater has been unplugged (or after a power failure), the time needs
to be set again.
D
IGNITING THE HEATER
When used for the first time, a new heater may give out a smell for a short while.
You should therefore provide extra ventilation. Always ignite the heater with the
button ¹. Never use matches or a cigarette lighter.
button ¹ to ignite the heater. The POWER lamp
Just press the
blinking, indicating that the ignition procedure has started. This will take a short
while. Once the heater is burning, the POWER lamp
information display ¸ will show two numbers. The light next to them indicates
that these numbers refer to the temperatures (Fig. F). The actual room temperature
is indicated below ROOM, while the temperature setting is indicated below SET.
The latter can be changed with the adjustment keys (refer to Section E).
Prior to igniting the heater, always check for sufficient fuel in the removable tank.
E

SETTING THE REQUIRED TEMPERATURE

The temperature setting can only be adjusted, when the heater is burning. Use the
adjustment keys
switch on the function (the °C mark and 4-digit ¸ will start blinking). Next, adjust
the temperature using the key on the right ( min.) to set the temperature to a
to adjust the temperature. First press either of the two keys to
while filling the tank (Fig. D). Stop
to set the time. First press
will remain lit (red). The
will start