Controller Installation - SELFSAT SNIPE BT Grey Line Bedienungsanleitung

G. Controller installation
G-1
Get Power input cable and plug into cigar
lighter socket (12V outlet)
G-3
12V DC
Match the power cables polarities to the
battery polarities, red to red / back to black and
white ignition cable to ignition port of the
vehicle
G-5
Place controller and plug the cables to the
controller (Power, signal and controller cables)
Ignition
ENGLISH - 21
G-2
To source power from car battery, cut off
cigar-jack connector to take inner three cables
out and peel off each to take copper cable out
G-4
Get Controller bracket, rear cable cover and
four(4) M4x20 bolt
G-6
If desire to place the controller on the wall, fix
the controller with provided bracket with
four(4) screws
Once all cables are connected, connection part
can be hidden using rear cable cover