Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Suspended installation
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. The installation must be carried out by a specialist
who is familiar with the hazards and the relevant regulations.
The device may be fastened to a truss or similar rigging structure. The device must never be fixed swinging freely
in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the device.
Please refer to the "Accessories" section for a list of suitable rigging hardware.
3
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment must
be sufficiently dimensioned in accordance with the latest industrial safety regulations and constructed in a way
that no part of the installation can fall down if the main attachment fails. Lead the safety rope through the
bracket and over the trussing. Fasten the safety rope in such a way that, in the event of a fall, the maximum
drop distance of the device will not exceed 20 cm.
4
To align the device, release the fixation screws at the mounting bracket, adjust the desired inclination angle and
tighten the fixation screws.
5
After installation, the device requires inspections periodically to prevent the possibility of corrosion, deformation
and looseness.
WARNING!
1) Hook
2) Trussing
3) Screw-on chain link
4) Safety rope
5) Mounting bracket
6) Fixation screw
Werbung
Inhaltsverzeichnis
