Cleaning And Maintenance - Steinberg Systems SBS-MT-100 Bedienungsanleitung

5. Remove the head cover.
6. Insert the test probes as deep as possible into the tested material.
7. The display shows the measured value.
8. Examine the material at several locations for the most accurate measurement.
9. To turn off the device, press and hold the switch.
10. It is possible to switch to automatic shutdown mode. In this mode, the device will
automatically turn off after 2 minutes of inactivity. To activate this mode, press the
switch while the device is already turned on.
FLASHLIGHT FUNCTION
To turn the flashlight on/off, press the flashlight function button.
RECORDING THE MEASUREMENTS
Measurement records are used to adjust the moisture level scale (based on the saved
measurements, the device indicates whether the current humidity level measurement
is low, medium or high).
1. When you press the H button, the reading value will be saved.
2. Holding the button down will save the current value as the maximum. During this
time, the MAX icon will appear in the upper left corner of the display.
CHANGING THE TEMPERATURE UNIT
1. To change the unit from
changes the measurement mode) for about 3 seconds.
3.3.
a) Store the unit in a dry, cool place, free from moisture and direct exposure to
sunlight.
b) Do not spray the device with a water jet or submerge it in water.
c) Use a soft cloth for cleaning.
d) Do not leave the battery in the device if it will not be used for a longer period
of time.
e) Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a
metal spatula) because they may damage the surface material of the
appliance.
SAFE REMOVAL OF BATTERIES AND RECHARGEABLE BATTERIES
C to F (or vice versa) hold the M button down (which
o o

Cleaning and maintenance