V-3-2-Thru-Hull Plugs - Zodiac OPEN Bedienungsanleitung

V-3-2-Thru-hull plugs

1
Out of the water (on trailer, cradle, etc.)
- Plugs in position (1)
In the water
While underway, plugs inserted in the thru-hull (2)
-
Water draining procedure.
-
INSTALLATION AND CIRCUIT - DRAINING
When stopped: plug in position (1), then navigate in planing position
-
(> 6 knots). Place parts back in position (2) when the water is drained.
At anchor:
-
At a temporary mooring or in other situations where the boat
-
is unlikely to take in large amounts of WATER (heavy rain,
breaking waves), place the parts in position (1) or (2).
- Long-term or risky anchorage: plugs out (1).
WARNING
If the boat takes in large amounts of water from the OUTSIDE (heavy rain,
wake,...) and the through-hulls are plugged, the boat risks being submerged
(swamped). The water taken on may then accumulate in the bilge and
make the boat much heavier causing it to lie low in the water and cause
serious damage to certain units such as the engine or the electrical circuits.
2
Page 50 / 67
issue 4