Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
CONNECTIONS
Power Supply
The device uses an auto-range power supply that accepts input voltages between 100 und 240 volts.
1
Connect the device via the enclosed mains cable to a grounded mains socket and switch on the device with the
power switch.
2
To switch off the unit, switch the power switch off.
3
Do not connect the unit to the mains voltage via a dimmer. For a more convenient operation, use a mains outlet
which is switchable.
4
The jack POWER OUT allows for power supply of further devices. To interconnect several devices, connect the
jack POWER OUT to the input POWER IN of the next unit until all units are connected. Matching power cables
are available as accessories. In this manner, up to 8 devices can be linked at 230/240 input voltage and up to 4
devices at 110/115 input voltage.
Connection DMX-Interface
The DMX-Interface is powered by the spotlight via USB connection.
DMX512 control
A DMX512 data link is required in order to control the device via DMX. The DMX interface module provides 3-pin
XLR connectors for DMX connection.
1
Connect the output of your DMX controller to the DMX input DMX IN of the device with a DMX cable.
2
Connect the DMX output DMX OUT of the device to the DMX input of the next unit in the chain. Always connect
one output to the input of the next unit until all units are connected.
3
At the last unit, the DMX cable has to be terminated. Plug the terminator with a 120 Ω resistor between Signal
(–) and Signal (+) in the DMX output of the last unit.
4
If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to
insert a DMX level amplifier to ensure proper data transmission.
XLR connection:
(optional accessory)
19/24
00138663, Version 1.0
Werbung
Inhaltsverzeichnis
