CONDTROL XLiner Pento 360 Bedienungsanleitung Seite 10

Pento 360 / Quattro 360 G / Pento 360 G
EN
CROSS LINE LASER
2) Projection of inclined planes
The switch bar is in position OFF.
Press and hold
Long press
Switched on laser lines will flash each 5 seconds.
After all possible combinations of lines are switched on, the next long
press
Long press
Attention! To increase operating time and avoid the risk of
unintentional blindness switch the laser on only when you are ready
to work.
If operated near objects or air streams with the temperature different
from the environment the laser line may tremble due to heterogeneity
of the atmosphere. The longer the distance, the more trembling of the
laser line can be observed.
The width of the laser line increases as soon as operating distance
increases as well. The layout should be made along the axis of the laser
line. For maximum accuracy, use the middle portion of the laser line.
It should be noted that the shape of the laser line on the object's
surface (e.g., walls, ceilings, etc.) depends on the curvature and tilt of
the surface relative to the laser line.
10 10
during 2 seconds to switch on the laser.
during 2 seconds to switch on required laser lines.
will switch off the laser level.
during 2 seconds to switch on/off the pulse mode.
user manual