Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Subsequently a vice can be installed on the platform.
3.3.
Working with the device
The device is operated with two levers. To adjust the position of the platform,
release the platform locking lever (C), set it to the desired height, then lock this
position with the lever (C).
When working with a vice is completed or you need to use the worktop for other
purposes, with this product you can easily hide the vice under the worktop (see
pictures below). To do this, release the folding lock lever (E), then tilt the platform
with the vice to the stop to the horizontal plane, i.e. parallel with the worktop,
lock the lever (E) and slide it under the worktop. In order to use a vice again,
unfold it in reverse direction to the order described above. These activities are
facilitated by the built-in actuator.
3.4.
Cleaning and maintenance
a)
Use only non-corrosive agents for cleaning the surface.
b)
Do not spray the device with a stream of water and do not immerse it in water.
c)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or metal
scraper) as these may damage the surface of the device.
Werbung
Inhaltsverzeichnis
