Personal Protective Equipment - Husqvarna FS 600 E Bedienungsanweisung

Personal protective equipment

WARNING:
instructions that follow before you use the
product.
• Always use approved personal protective equipment
when you operate the product. Personal protective
equipment cannot fully prevent injury but it
decreases the degree of injury if an accident does
occur. Let your dealer help you select the correct
personal protective equipment.
• Regularly do a check of the condition of the personal
protective equipment.
• Use an approved protective helmet.
• Use approved hearing protection.
• Use approved respiratory protection.
• Use approved eye protection with side protection.
There is a high risk of eye injury from thrown objects.
• Use protective gloves.
• Use boots with steel toe-cap and non-slip sole.
• Use approved work clothing or equivalent close-
fitting clothing that has long sleeves and long legs.
Fire extinguisher
• Keep a fire extinguisher near during operation.
• Use a powder fire extinguisher or a carbon dioxide
fire extinguisher.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
• Do not use a product with defective safety devices.
• Do a check of the safety devices regularly. If
the safety devices are defective, speak to your
Husqvarna service agent.
ON button and OFF button
The ON button (I) and OFF button (0) is used to start
and stop the motor.
1620 - 004 -
Read the warning
Read the warning
To do a check of the ON button and OFF button
Note:
If the product does not start, refer to
product does not start on page 24 .
1. Disconnect the product from the mains outlet.
2. Make sure that the cutting blade is slightly above the
ground.
3. Make sure that the cutting blade and the blade
flange are tightly attached and the blade guard is
correctly installed. Refer to
on page 12 and To install the blade guard on page
14 .
4. Connect the product with an extension cord to the
mains outlet.
5. Turn the machine stop button (STOP) clockwise to
make sure that it is disengaged.
6. Push the ON/OFF button to "I" to start the product.
7. Wait for 5 seconds to let the product operate at the
correct speed.
8. Push the ON/OFF button to "0" and make sure that
the motor stops.
Machine stop button
The machine stop button (STOP) stops the motor. The
machine stop button does not stop the lights.
Note:
Do not use the machine stop button to stop
the product unless there is an emergency. For correct
procedure how to stop the product during operation,
refer to To stop the product on page 19 .
The
To install a cutting blade
9